ATMega168 64 channel servo controller with 'advanced' servo commands

| No Comments
This is the AVR Studio project and assembly language source code files for the latest version (v7.0) of my 64 channel serial servo controller.

This is the latest version of the ATMega168 version of the code which includes all of the new servo commands that I wrote about here including the multi-move command and the unit tests that I spoke of here. The controller allows you to set minimum, maximum and startup servo positions for each servo which can be saved into eeprom and used every time the controller is powered up. It also includes a programmable, per servo, "centre adjust" value which can be used to adjust for servos that are installed slightly off centre.

Source code is available here.


Leave a comment

About this Entry

This page contains a single entry by Len published on November 29, 2009 7:51 PM.

Back to JIT testing was the previous entry in this blog.

New soldering iron... is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.